Anviz EP300 Basic Guide (Applicable to W1 Pro): Modify User

To read the full guide with pictures, click here: Anviz EP300 Basic Guide

1. On the Main screen, press 2 (or use the Left/IN and OUT/Right to navigate to User and press OK).

2. On the User screen press 2 (or use the Left/IN and OUT/Right to navigate to Modify and press OK).

3. Input an existing user’s ID. If you input a non-existent ID, you will not be allowed to proceed. Press OK when finished to proceed.

4. Input the existing user’s new name. You may press OK to skip to the next step if you do not wish to modify the existing user’s name. The FN button will allow for more advanced input such as letters and special characters (see Advanced Input). Press OK when finished to proceed.

5. Input the existing user’s new password. You may press OK to skip to the next step if you do not wish to modify the existing user’s password. This field can only contain numbers. Press OK when finished to proceed. You may press OK a second time to proceed further as this guide does not cover card usage. NOTE: This step is optional. A password is not mandatory.

6. Choose the existing user’s new shift hours (see Set Work Shifts). You may press OK to skip to the next step if you do not wish to modify the existing user’s shift. Press Left/IN and OUT/Right to cycle through available shifts. Press OK when finished to proceed.

7. Choose whether the existing user will be a regular user or an admin (see Admin Levels). You may press OK to skip to the next step if you do not wish to modify the existing user’s status. Press Left/IN and OUT/Right to cycle through types. Press OK when finished to proceed.

8. Press OK to enroll existing user’s fingerprints (see Enroll User Fingerprints) if they do not have them enrolled yet. You may press OUT/Right to skip to the next step if you do not wish to enroll the existing user’s fingerprints. Press M/Back when finished to go back to the Modify screen. Press OUT/Right when finished to proceed.

9. Press OK to choose the existing user’s verification mode (see Verification Modes). You may press M/Back to immediately finish the modification and leave the Modify screen if you do not wish to modify the existing user’s verification mode. To change verification mode, press OK to disable System default (see Default Verification Modes). Press Left/IN and OUT/Right to cycle through verification modes and press OK to enable or disable them. Press M/Back when finished to leave the verification mode screen, then press M/Back again to leave the Modify screen. The existing user has been updated.